46 | Implementing the Network
Aprisa SRx User Manual 1.3.0
Network Changes
Adding a Repeater Station
To add a repeater station to your network:
1. Install the repeater station radio (see ‘Installing the Radio’ on page 54).
2. Set the radio Network ID to the same ID as the other stations in the network (see ‘Terminal > Device’
on page 82).
3. Set the radio IP address (see ‘IP > IP Setup’ on page 121).
4. Set the radio frequencies to the base station frequencies you wish to operate from (see ‘Radio > Radio
Setup’ on page 92).
5. Set the radio operating mode to ‘repeater station’ (see ‘Terminal > Operating Mode’ on page 87).
6. Increase the radio network radius by one on all stations in the network (see ‘Terminal > Device’ on
page 82).
The base station will automatically allocate a node address to the new repeater station.
To remove a repeater station from your network:
1. Turn the power off on the remote station radios operating from the repeater station radio you wish to
remove.
2. Turn the power off on the repeater station radio you wish to remove.
3. Decrease the network radius by one on all stations in the network (see ‘Terminal > Device’ on page
82).
Adding a Remote Station
To add a remote station to your network:
1. Install the remote station radio (see ‘Installing the Radio’ on page 54).
2. Set the radio Network ID to the same ID as the other stations in the network (see ‘Terminal > Device’
on page 82).
3. If repeater used in radius 1, set the network radius=2 on all network stations (see ‘Terminal > Device’
on page 82).
4. Set the radio IP address (see ‘IP > IP Setup’ on page 121).
5. Set the radio frequencies to the base station / repeater station frequencies you wish to operate from
(see ‘Radio > Radio Setup’ on page 92).
6. Set the radio operating mode to ‘remote station’ (see ‘Terminal > Operating Mode’ on page 87).
The base station will automatically allocate a node address to the new remote station.
To remove a remote station from your network:
1. Turn the power off on the remote station radio you wish to remove. This is the only action that is
required.
Note: The remote station will continue to show in the Network Table list.
To Next Page
Loading...
