4RF Aprisa SR - Page 86

84 | Managing the Radio
Aprisa SRx User Manual 1.3.0
The Network Repeaters Proximity options are dependent on the Terminal Operating Mode and the
Terminal Network Radius settings:
Operating Mode
Network Radius
Network Repeaters Proximity Options
Default
Base
1
No Repeater
No Repeater
Base
2
Single Repeater Only, Overlapping
Coverage, Separated Coverage
Single Repeater Only
Remote
1
No Repeater, Base Repeater
No Repeater
Remote
2
Single Repeater Only, Overlapping
Coverage, Separated Coverage
Single Repeater Only
Repeater
1
No Repeater, Base Repeater
No Repeater
Repeater
2
Single Repeater Only, Overlapping
Coverage, Separated Coverage
Single Repeater Only
Base Repeater
1
Base Repeater
Base Repeater
Base Repeater
2
Single Repeater Only, Overlapping
Coverage, Separated Coverage
Single Repeater Only
Inband Management
This parameter sets the Inband Management option.
If the Inband Management option is enabled, SuperVisor operating on a base station can also manage all
the remote / repeater stations in the network.
Inband Management Timeout (sec)
This parameter sets the Inband Management timeout period. This determines the time the base station
waits for a response from a Remote or repeater station before aborting the Inband Management request.
The default setting is 10 seconds.
REGION SETTINGS
Time Format
This parameter sets the time format for all time based results.
The default setting is 24 Hours.
Date Format
This parameter sets the date format for date based results.
The default setting is DD/MM/YYYY.
Measurement System
This parameter sets the unit type for parameters like temperature readings.
The default setting is Metric.