DECT Measuring Device ME-8 (test kit)
60
Planning Aastra 400 DECT systems as of R1.0
syd-0457/1.0 – R1.0 – 10.2012
Saving a System ID:
After scanning all systems (X), the radio units of the different systems are listed un-
sorted. To display only the visible radio units of a particular system, the required
system ID is saved under the system designation ”E” and then selected:
1. In ”Look-around mode” across all systems (X) press the ”M” key
2. Press the Foxkey "Store->E" (Note: The menu item appears only after the scan
procedure is completed.)
3. Select a radio unit of the desired system with Foxkey ”>” or ”<”
4. Confirm with Foxkey "OK"
5. Press Foxkey "System"
6. Select system designation ”E” with Foxkey ”>”
7. Confirm with Foxkey "OK"
8. The scan procedure starts automatically and only the radio units with this sys-
tem ID are displayed in the list.
Note:
The selected system is permanently saved and is maintained even after switching
off the cordless phone.
Display Backlighting
1)
During the measuring procedure it may be practical to have the display on the
cordless phone continually backlit. The backlighting mode can be set on the test
phone via the menu.
1. Press ”M” in ”Look Around Mode” until "Light" appears
2. Press Foxkey "Light"
3. Use Foxkey ”>” to select the desired backlighting
4. Confirm with Foxkey "OK"
Tip:
Long-click 7 to go directly to this menu.
1)
Possible only with a test phone
1)
Possible only with a test phone
To Next Page
Loading...
