DECT Measuring Device ME-8 (test kit)
58
Planning Aastra 400 DECT systems as of R1.0
syd-0457/1.0 – R1.0 – 10.2012
6. 3. 1. 2 Settings in "Look Around Mode"
Selecting a DECT System
1. In ”Look Around Mode” press the ”M” key repeatedly until "System" appears
2. Press Foxkey "System"
3. Use the Foxkey ”>” to select the system designation
4. Confirm with Foxkey "OK"
Tip:
Long-click 1 to change the system.
Tab. 4 Significance of the system designations:
Note:
The selected system is permanently saved and is maintained even after switching
off the cordless phone.
Designation Icon Meaning Note
A, B, C, D A, B, C, D Systems of the valid cordless
phone registrations
Only visible if the cordless phonr is regis-
tered in these systems
E E Saved system Visible only if a system was previously saved
(see section ”Saving a System ID:”)
Test T Test system Contains only the visible test radio units in
measuring mode
Xall X All systems Contains all visible radio units
To Next Page
Loading...
