Aastra 400 Series - Page 57

DECT Measuring Device ME-8 (test kit)
57
Planning Aastra 400 DECT systems as of R1.0
syd-0457/1.0 – R1.0 – 10.2012
Detail Display ”Bearer Information”
Pressing the ”i” key again takes you to the ”Bearer information” detail display. Lines
3 and 4 in this display show the current values for "Traffic Bearer" and "Synchronisa-
tion Bearer". The values of the "Traffic-Bearer" are not visible until a call connection
has been set up. The ”Connection quality” detail display in the 2nd line remains the
same.
Fig. 27 3th and 4th lines of the ”Bearer information” detail display in "Look Around Mode"
ED
D42? 4D 4D
"Synchronisation Bearer":
Location Area ID (0..3)
Last 4 digits (hex) of the system ID
"Trac Bearer":
Location Area ID (0..3)
"Trac Bearer":
Identity of the radio unit (00..3F)
Left Foxkey:
"scan": Start the scan procedure
"stop": Cancel the scan procedure
"Synchronisation Bearer":
Identity of the radio unit (00..3F)
3. + 4. line: Detail display of ”Bearer information”
"Synchronisation Bearer":
current carrier (c=”carrier”) and time slot (s=”slot”)
"Trac Bearer":
current carrier (c=”carrier”) and time slot (s=”slot”)