DECT Measuring Device ME-8 (test kit)
66
Planning Aastra 400 DECT systems as of R1.0
syd-0457/1.0 – R1.0 – 10.2012
6. 3. 2 "Show Measurement Mode"
This mode is available without limitation both with a standard cordless phone and
a test cordless phone. A prerequisite, however, is that the cordless phone is regis-
tered on system A, B, C or D and is connected to a radio unit (locked).
Activating the ”Show Measurement Mode”:
1. Long-click key ”4”:
The display switches for 7 seconds to ”Show Measurement Mode”. Line 2 shows
the field strength and call quality (see Fig. 23); line 3 shows the ”Bearer informa-
tion” detail display (see Fig. 27). The 4th line shows the information for switching
to the permanent display mode (”to keep test: LC#").
2. Long-click ”#” within 7 seconds:
The display remains permanently in ”Show Measurement Mode”. Lines 3 and 4
show the ”Bearer information” detail display (see Detail Display ”Bearer Informa-
tion”, page 57).
Note: Instead of Foxkey "scan", a "Connection handover" or a "Bearer handover"
is also displayed (see Fig. 29).
3. Long clicking ”#” again switches the 2nd line to the ”Call quality” detail display
(see Detail Display of ”Connection Quality”, page 56).
Note: The information about whether the current radio unit is working with the
internal or external antennas is not available in this mode.
4. Further long-clicks of the "#" key resets the field strength minimum displays and
the counter of the CRC errors (see Detail Display of ”Connection Quality”, page
56).
Exiting the ”Show Measurement Mode”:
Long-click 4 or long-click C
Keyboard assignment in "Show Measurement Mode"
The keyboard assignment (short-click or long-click) in ”Show Measurement Mode”
is identical to normal cordless phone operation with the exception of long-click 4
and long-click # (see the previous section for a description).
To Next Page
Loading...
