Aastra 400 Series - Page 54

DECT Measuring Device ME-8 (test kit)
54
Planning Aastra 400 DECT systems as of R1.0
syd-0457/1.0 – R1.0 – 10.2012
Fig. 21 Standard display in "Look Around Mode"
Depending on the state, additional icons and other strings are visible.
Standard Display
The meaning of the relevant standard display icons and strings in "Look Around
Mode" are explained line by line in the following:
Fig. 22 1st line of the standard display in "Look Around Mode"
Fig. 23 2nd line of the standard display in "Look Around Mode"
#  
A6C764E
=@4<.
D42?`
1. line: Icons
2. line: Field strength and call quality
3. line: Status and supplementary information
4. line: Fox menu and supplementary information
&&&&&&&&&#&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&
1. line: Icons
Setting up a ringing or call connection active
( relevant only with test phone)
Loud speaker on/o (relevant only with test phone)
Microphone on/o (relevant only with test phone)
Press the "M" key for more menus
Battery status of the test phone
Press the "i" key for more information
Current DECT system (A, B, C, D, E, T, X, ashes if no connection)
Field strength averaged (not visible if no connection)
Call connection status (ashes if no connection)
_A6C764E
Additional eld strength display information:
? : Single value from scan procedure (snapshot)
+ : top measurement limit reached
Filtered eld strength display (RSSI)
2. line: Field strength and call quality
Call quality display
4 bars: (>54): “perfect”: very good speech quality
3 bars: (45-54): "good": good speech quality
2 bars: (35-44): "fair": Call interruptions may occur
1 bars: (25-34): "bad": Frequent call interruptions
0 bars: (<25): "lousy": No stable connection possible.