Aastra 400 Series - Page 55

DECT Measuring Device ME-8 (test kit)
55
Planning Aastra 400 DECT systems as of R1.0
syd-0457/1.0 – R1.0 – 10.2012
Fig. 24 3rd line of the standard display in "Look Around Mode"
Fig. 25 4. line of the standard display in "Look Around Mode"
=@4<3.
3. line: Status and supplementary information
"Handover Mode":
X: Handover switched o
H: Handover switched on
Battery status of the test radio unit:
(only available with locked test phone)
No display: Battery charged
b: Battery charge critical
Location Area ID (0..3)
Identity of the radio unit (00..3F)
Last 4 digits (hex) of the system ID
Long-clicking 2 temporarily shows the complete system ID.
Status information:
"idle": No activity
"scan": Scan procedure for DECT carrier frequencies active
"srch": Attempting to set up a connection to the selected radio unit
“look”: Active connection to your radio unit present (locked)
"ring": Test phone is being called by another test phone
"call": Test phone is calling another test phone
"conn": Test phone has a call connection to another test phone
"loop": Test phone is in ”Loopback Mode”
DE@
A
`
`
`
“”
`
“”
`
“”
“”
`
(longclick
4. line: Fox menu and supplementary information
Number of found radio units during the scan
procedure (information)
Dialled radio unit (information)
Left Foxkey:
"scan": Start the scan procedure
"stop": Cancel the scan procedure
Right Foxkey:
Select next radio unit from the list
Select previous radio unit from the list
switches to
and vice versa)