DECT Measuring Device ME-8 (test kit)
65
Planning Aastra 400 DECT systems as of R1.0
syd-0457/1.0 – R1.0 – 10.2012
Tab. 7 Long key press (”long-click”) in ”Look Around Mode”
i Change between displays see Fig. 20
Call key Set up / clear down call connection to another test
phone, clear down loopback connection
Available only with test phone under
system ”T” (see page 61)
0..9 Under system ”T”: Switch to test radio unit 1..8, oth-
erwise: change to corresponding radio unit from
the scan list (0 corresponds to entry 10)
(see page 59)
Set up loopback connection with test radio unit Available only with test phone under
system ”T” (see page 61)
# Reset field strength minimum and CRC errors dis-
plays
Long-click ”#” also possible (see
Fig. 26)
Loudspeaker key Switch hands-free operation on/off Available only with test phone under
system ”T” (see page 62)
Hotkey not available
Key Meaning Note
Foxkey left -
Foxkey right Change scroll direction
(long-click ”>” switches to "<” and vice versa)
Not available in all menus
M not available (see page 53)
C Exit "Look Around Mode" (see page 53)
i- (see page 53)
Call key not available (see page 53)
0 Switch cordless phone on/off
1 Select next system (A, B, C, D, E, T, X) (see page 58)
2 Display complete system ID (see Fig. 24)
3 Indicates the cordless phone’s internal diagnostics
4 Exit "Look Around Mode" (see page 53)
5 Displays the SW version of the test software
5 + 1 Request ”Connection handover”
5 + 4 Request ”Bearer handover”
5 + 5 Displays the internal SW version
6 Indicates battery charge status and the type
7 Go directly to menu for display backlighting Available only with a test phone
8 not available
9 not available
not available
# Reset field strength minimum and CRC errors dis-
plays
Also possible with short-click ”#” (see
Fig. 26)
Hotkey not available
Key Meaning Note
To Next Page
Loading...
