Ascotel® IntelliGate® 150/300 as of I7.9
114 Installation
syd-0210/1.7 – I7.9 – 12.2009
Jumper Configuration
The jumper configuration is shown in the following diagram. Three of the four IO
ports are used for connecting the door intercom. A control input or a relay output is
available for other purposes.
Fig. 58 Jumper configuration for connecting a door intercom
Note
If the options card is fitted to slot IC2 (A150) or slot IC4 (A300), the jump-
ers of ports Port 1, 2 and 3 must be fitted as shown in Fig. 58.
Connector assignment
Tab. 47 Connection in slot 2 (A150) or slot 4 (A300)
RJ45 A150/300 RJ45 A150/300
Socket X1 Pin Signal Socket X3 Pin Signal
1– 1–
2– 2–
3KT1 3 Tb
4TS2 4 –
5TS1 5 –
6KT2 6 Ta
7– 7–
8– 8–
Socket X2 Pin Signal Socket X4 Pin Signal
0ORT
0ORT
0ORT
0ORT
)/
4/
43
+4
&REECONTROLINPUTDRAWNORFREERELAYINDICATED
#ONFIGUREDFORCONNECTINGADOORINTERCOM
To Next Page
Loading...
