Ascotel® IntelliGate® 150/300 as of I7.9
Installation 127
syd-0210/1.7 – I7.9 – 12.2009
Settings
The same communication parameters must be set on all the connected equip-
ment. On the PA this is done using DIP switches S1... S8 (see Fig. 66).
Fig. 66 DIP switches
Connection
DIP switches S1 and S3 are used for setting the two pieces of equipment that are to
communicate with each other via the PA.
Tab. 59 Setting the connection
Example:
V.24 (B) ↔ AD2 terminal
Connects the system terminal with PC or Mac
Switch S1 Switch S3 Connections
ON ON Reserve
ON OFF V.24 (B) ↔ AD2 terminal
OFF ON V.24 (A) ↔ V.24 (B)
OFF OFF V.24 (A) ↔ AD2 terminal
ON
S8
S7
S6
S5
S4
S3
S2
S1
Transmission rate
Flow control
Connection
"ON" TSD2
Connection
haz1144aaena0
To Next Page
Loading...
