Ascotel® IntelliGate® 150/300 as of I7.9
194 Operation and Maintenance
syd-0210/1.7 – I7.9 – 12.2009
Node:
Connection re-established
A node is reconnected with the Master for a
certain amount of time (configurable) after an
interruption.
Node number, date, time
NTP: Synchronisation failed Time synchronization via the NTP server (NTP
= Network Time Protocol) has failed.
Date, time
NTP: Synchronisation rees-
tablished
Time synchronization via the NTP server (NTP
= Network Time Protocol) has been restored.
Date, time
Numbers missing Card(s) not full logged on
• Insufficient memory reserved in the num-
bering plan to enable allocation of numbers
to all users: Type in missing numbers by
hand
Date, time
Outgoing call rejected Call rejected by the network
• On any line: error code 34
• On required line group:
error code 44
Port number of the exchange
line circuit, cause, date, time
Overheat The temperature inside the housing is too
high.
Date, time
Port out of service A port previously in operation has stopped
functioning.
Number of the slot, relevant
port number, date, time
QSIG licence limit reached Maximum number of licensed outgoing con-
nections with QSIG protocol exceeded
Route number, user number,
date, time
Recording error • Card not fitted
• Card not logged on
• Card defective
Card number, date, time
Remote maintenance is acti-
vated
Remote maintenance has been activated Unfiltered output to local desti-
nations
Reset card A reset was carried out for one card Number of the expansion slot,
date, time
Satellites missing after super-
vision time
After an AIN update (Master and all satellites)
some satellites no longer have a connection
to the Master.
Total satellites missing, Satel-
lites rolled back, Date, Time
SIP account available The SIP account is unable to register with the
SIP provider for a specific reason (0: Provider
cannot be reached / 1: No authorization). The
event is triggered only if the parameter "Regis-
tration required" is configured to "Ye s".
Provider, account, date, time
SIP account available The SIP account has successfully registered
with the SIP provider.
Provider, account, date, time
Software upload During an upload in PBX status:
• "Update running"
•"Supervision running"
•"Normal running"
• "New PBX software loaded,
starting..."
• "New PBX software crashed,
rollback executed"
• "New PBX software started,
running fault-free"
Date, time
Event/ error message Trigger condition Details
To Next Page
Loading...
