Ascotel® IntelliGate® 150/300 as of I7.9
28 Expansion Stages and System Limits
syd-0210/1.7 – I7.9 – 12.2009
Selectable additional functions of the basic systems
The basic systems provide expanded additional functions as indicated in the fol-
lowing table. All the possible combinations are listed, with the maximum number
of voice channels. For this the DSP chip on the mainboard has to be loaded with
different firmware. Additional functions require the use of one or more DSP mod-
ules. Some of these functions are subject to a licence.
The additional functions are determined under CM_1_1_7 in the AIMS Configura-
tion Manager. A description of the individual functions can be found as of page 33.
Tab. 5 Selectable additional functions of the basic systems
Notes
– To be able to configure VoIP channels on the mainboard’s DSP, make
sure the VoIP mode parameter is configured to Only VoIP-G.711. The
configured VoIP mode is valid for all the DSP chips of a node. The fol-
lowing also applies to this mode:
- Two VoIP channels per system can be used without a licence.
- The VoIP channels of the mainboard can be combined with VoIP
channels of DSP cards.
– If Voice Mail channels are configured, the two basic Voice Mail chan-
nels that can be used without a licence are redundant (see Tab. 4).
– Voice Mail channels can only be configured on one DSP chip per node.
–The Modem function is used for remote maintenance via an analogue
modem and can only be configured on the mainboard’s DSP.
– The system has to be restarted for the configuration changes of the
DSP to take effect.
DECT VoIP
1)
1)
Licences required (see also "Licence-related system limits", page 47).
Voice
mail
1)
GSM
1)
Modem Remarks
4 Default configuration
228
48
3 2 of which can be used without a licence
1
To Next Page
Loading...
