Aastra Clearspan 6731i - Phone Features; General Requirements; Handset;Headset Connection

___________________________________________________________________________________________
CS AASTRA 6731i IP PHONE USER GUIDE V3.2.2 AASTRA – 2817-002
CLEARSPAN® IS A RGISTERED TRADEMARK OF AASTRA TECHNOLOGIES LTD. PAGE 16 OF 82
2.2.1 Phone Features
 3-line LCD screen.
 2 line appearance keys (L1 – L2) with corresponding status lamps.
 Press-and-hold speeddial key configuration feature
 8 top programmable hard keys with status lamps.
 Supports up to 6 call lines.
 Full-duplex speaker for handsfree calls.
 Headset/headset modular connector.
 Built-in-two-port, 10/100 Ethernet switch allowing you to share a connection with your
computer.
2.2.2 General Requirements
The 6731i requires the following environment:
 A SIP-based IP PBX system or network installed and running with a SIP account created for
the 6731i.
 Access to a Trivial File Transfer Protocol (TFTP) server.
 Ethernet/Fast Ethernet LAN (10/100mb).
 Category 5/5e straight through cabling.
 Power Options:
 Power over Ethernet (PoE) 802.3af.
 Inline power injector – An optional accessory necessary only if your network provides no
inline power.
 AC power adapter, included with the phone.
2.3 Handset/Headset Connection
The 6731i supports a handset or headset using the same jack. Both a handset and a headset
cannot be connected at the same time.
Turn the phone over and locate the handset jack marked . Insert one end of handset or
headset cord into the jack until it clicks into place. Then route the cord through the groove as
shown in the illustration below.