Aastra Clearspan 6731i - Park and Pickup; Default Display; Use Park and Pickup

___________________________________________________________________________________________
CS AASTRA 6731i IP PHONE USER GUIDE V3.2.2 AASTRA – 2817-002
CLEARSPAN® IS A RGISTERED TRADEMARK OF AASTRA TECHNOLOGIES LTD. PAGE 53 OF 82
Drop a party from an active conference:
1.
Use or to point to the party to drop.
You remain connected to the other party.
2.
Press Drop.
Conference two separate calls already on hold:
1.
Press Conf.
Both calls are on hold.
2.
Press the Line key of the first held call.
The first line is connected.
3.
Press Conf again.
4.
Press the Line key of the second held
call.
The conference is established.
Leave a Conference:
1.
Press Leave.
The other two parties remain connected.
6.6 Park and Pickup
The Call Park feature allows you to park a call so that any member of the group can retrieve it.
A call can be parked against any number in the group, including your own number.
You can only have one call parked at a time.
A 45-second timer is started when you park a call. If the timer expires and your line is idle, the
system rings your line. If you line is not idle, the timer is restarted for 10 seconds and the call
remains parked. This procedure is repeated until your line is idle, or the parked call is retrieved or
released.
6.6.1 Default Display
 The Park key is visible only when a call is connected.
 The Pickup key is visible only the phone is idle or when the phone is off hook.
6.6.2 Use Park and Pickup
Step
Action
Result
Park a Call:
1.
From a connected call:
Press the Park key.
The feature access code for Park is
dialed and you hear instructions given by
the system.
2.
 Dial the number where you want to
park the call plus the key.
Or
 Dial to park the call against
your number.
If the call is parked successfully, you hear
the message “Your call has been Parked.
Thank you.”