AMT/PTD/TR/0001/3/7/EN Installation Manual for digital sets - IP sets - SIP sets
Page 5-34 05/2008 To install sets and cartridges in the i7XX range
5.4.4.9 Logging out – before R3.2
The purpose of the Log out procedure is to allocate another number to a logged set.
To log out a set, the following operations must be carried out:
• Unplug and plug the set back in. An initialisation phase is activated (at the end of this
initialisation phase, a question mark is displayed to the left of the display)
• Enter the following sequence within 5 seconds:
* 1("Prog"*1) used to enter network parameters in the configuration menu; the "Phone
number" option is displayed.
Description:
Then, the standby screen is displayed with a prompt to enter a directory number like the first time
the set was started.
WRGHOHWHE\SUHVVLQJ
VXFFHVVLYHO\
'LVSOD\RIWKH
'LUHFWRU\
8QSOXJWKHQSRZHUXS
DJDLQ
WRGHOHWHE\SUHVVLQJ
VXFFHVVLYHO\
$IWHUGHOHWLRQ
'LVFRQQHFWLRQLQLWLDWHG
To Next Page
Loading...
