AMT/PTD/TR/0001/3/7/EN Installation Manual for digital sets - IP sets - SIP sets
Page 8-12 05/2008 SIP PHONEs 480i, 9112i and 9133i
8.7 Architectures of NeXspan with SIP phones
The SIP phones are declared in the iPBX (NCS or NeXspan), but are connected via the SIP
access point. This SIP access point can be hosted by NCS, the IPS card of a NeXspan or
NeXspan SIP Access Point (NSAP).
The SIP phones must be connected to the SIP access point corresponding to the NeXspan site on
which them subscription is declared.
8.7.1 Architecture using the SIP access point in NCS
Figure 8.4 Architecture using the SIP access point in NCS
The SIP phones are connected either on a phone VLAN, or a Data VLAN in 802.1Q if a PC is
connected. They are connected to the SIP Proxy located in NCS.
A TFTP server is also included in NCS (PumpKIN freeware). It allows you to download SIP phones
(firmware and configuration).
A DHCP server for providing IP addresses, and an NTP server for setting time on the devices must
be accessible from the ToIP VLAN.
A level 3 Ethernet switch is used for inter-VLAN routing, as well as DHCP relay for devices outside
the Data VLAN.
1&6
&DOO6HUYHU
3UR[\6,3
7)73 VHUYHU
1&6
&DOO6HUYHU
3UR[\6,3
7)73 VHUYHU
1&6
&DOO6HUYHU
3UR[\6,3
7)73 VHUYHU
9/$1
µ7HOHSKRQ\¶
'DWD9/$1
3KRQH9/$1
4OLQN
6,3DFFHVVSRLQW
7)73VHUYHU