Installation Manual for digital sets - IP sets - SIP sets AMT/PTD/TR/0001/3/7/EN
To install sets and cartridges in the i7XX range 05/2008 Page 5-45
5.5.4.8 To log out
To log out a set, the following operations must be carried out:
• Unplug and plug the set back in. An initialisation phase is activated (at the end of this
initialisation phase, a question mark is displayed to the left of the display)
• Enter the following sequence within 5 seconds:
* 1 used to enter network parameters in the configuration menu; the menu's "Phone number" is
displayed.
Then, the standby screen is displayed with a prompt to enter a directory number:
Then, after entering the set n°, enter the code.
0
5[\[\[
8SOXJWKHQSRZHU
XSDJDLQ
"
L 5[\[\[
L 5[\[\[
3KRQHQXPEHU
3KRQHQXPEHU
'LVSOD\RIWKH
'LUHFWRU\QXPEHURSWLRQ
3DVVZRUG
3OHDVHZDLWVWRUDJHLQSURJUHVV«
'LVFRQQHFWLRQLQLWLDWHG
(17(5<2856(71R
&RPP
To Next Page
Loading...
