AMT/PTD/TR/0001/3/7/EN Installation Manual for digital sets - IP sets - SIP sets
Page 5-52 05/2008 To install sets and cartridges in the i7XX range
5.6.4.9 Summary of installer codes used
Access condition: Code: Function:
After power up, at the end of the
initialisation period, when "?" is
displayed and within 5s
* 1 Configuring network parameters
In standby and during a call * 2 Viewing the configured parameters
After power up, at the end of the
initialisation period, when "?" is
displayed and within 5s
Accessible at any moment as from set
version R5.3
* 5 Viewing the identification parameters
After power up, at the end of the
initialisation period, when "?" is
displayed and within 5s
* 7 Configure Ethernet parameters
In standby (as from set version R5.3) * * Restarting the set
After power up, followed by to
validate
* 9 Return to the default IP configuration (total
DHCP, disappearance of subscriber’s
number).
To Next Page
Loading...
