3BSE036351-510 A 19
Safety Summary (continued)
SPECIFIC
WARNINGS
(continued)
Page 124: The CI862 baseplate has no locking device. Insert only the
CI862 unit into this baseplate. Insertion of other unit types may cause
damage to the equipment.
Page 191: Before attempting maintenance or troubleshooting, read the
Safety Summary on page 13. Failure to do so could lead to personal
injury or damage to equipment.
Page 198: It is not allowed to manipulate CEX bus baseplates in a pow-
ered and running system. Before changing or removing a baseplate, all
CEX modules on that segment must be removed.
Page 429: Explosion hazard - Substitution of components may impair
suitability for Class I, Zone 2.
Page 429: Explosion hazard - Do not replace batteries unless the power
has been switched off or the area is known to be non-hazardous.
Page 430: Explosion hazard - Do not disconnect equipment unless the
power has been switched off or the area is known to be non-hazardous.
SPECIFIC
CAUTIONS
Page 68: To prevent damage to the pins, be sure the baseplate plugs and
sockets are fully aligned as the units interconnect. Under no circum-
stances use excessive force!
Page 68: It is essential that the locking device be placed in the LOCKED
position to avoid possible problems caused by vibration and/or intermittent
grounding.
Page 73: In order to provide adequate access and removal space, note
that the SLIDE sequence must be carried out on the unit baseplates adja-
cent to the unit that is to be removed.
Page 73: The unit baseplates are easily disconnected from each other by
gently prying them apart with a blade screwdriver (see Figure 23 on page
74).
To Next Page
Loading...
Need help?
General
