ABB AC500 - Page 108

____________________________________________________________________________________________________________
G1 Introduction to AC500 1-106 AC500 / Issued: 07.2006
The parameter settings of the communication coupler can be easily modified by double clicking on the
coupler symbol (surrounded by a blue line). A window opens - click on "Configuration -> Bus
Parameters". With that you can change the parameters.
Change the desired parameters and then click OK.
The same procedure is used to append a slave to the PROFIBUS DP master CM572-DPM. Open the
"Slave" folder in the "Fieldbus" tab. Drag the PROFIBUS DP FieldBusPlug PDP22-FBP (DPV1 modular)
into the left-hand window to append it to the purple line (this line represents the PROFIBUS DP fieldbus).