ABB AC500 - Configuring the Digital I;O Module DC 532; Configuring the I;O Parameters

____________________________________________________________________________________________________________
G1 Introduction to AC500 1-82 AC500 / Issued: 07.2006
Select "Append Subelement" -> "DC532" (or the I/O module You use).
Configuring the digital I/O module DC 532
Configuring the I/O parameters
Click on . Double click the object "PLC Configuration". By clicking on the I/O symbol, the
module parameters are displayed and can be changed. Example for DC532: The input delay is changed
from 8 ms (default) to 1 ms.
This way you can also configure the inputs and outputs of the S500-FBP interface module DC505-FBP
in order to use them as decentralized inputs and outputs.