____________________________________________________________________________________________________________
G1 Introduction to AC500 1-33 AC500 / Issued: 07.2006
well as the S500 User's manual for additional installation requirements
pertaining to this equipment.
Before starting
Use this document as a guide for installing and powering-up your AC500 PLC. You should already be
familiar with the system components.
How to handle AC500 components
ATTENTION
Preventing Electrostatic Discharge
This equipment is sensitive to electrostatic discharge, which can cause internal
damage and affect normal operation. Follow these guidelines when you handle
this equipment:
• Touch a grounded object to discharge potential static.
• Wear an approved grounding wrist strap.
• Do not touch connectors or pins on component boards.
• Do not touch circuit components inside the equipment.
• If available, use a static-safe workstation.
• When not in use, store the equipment in appropriate static-safe
packaging.
Make sure that you have all the components you need
To use the AC500 PLC (in our example CPU PM581-ETH) you should use at least the following parts:
Part Number Designation
1SAP 1121 00 R0170 TB521-ETH Terminal Base for CPU with 2 coupler slots
1SAP 1401 00 R0170 PM581-ETH CPU
1SAP 1806 00 R0001 TA524 Dummy coupler module to cover the unused coupler slots
1SAP 1802 00 R0001 TK501 Programming Cable D-Sub / D-Sub
Optional:
Part Number Designation
1SAP 1803 00 R0001 TA521 Lithium Battery
1SAP 1801 00 R0001 MC502 Memory SD-Card
To Next Page
Loading...
