____________________________________________________________________________________________________________
G1 Introduction to AC500 1-77 AC500 / Issued: 07.2006
Task: Assign an input signal to an output.
In this example, we are using the programming language FBD.
Preparations
• Connect the PM581 controller to 24 V DC. Connect the DC532 I/O module to 24 V DC. Connect
the COM2 interface of the controller to the COM1 interface of the PC or use an USB RS-232
converter and connect it to the USB interface of the PC.
• Start the PS501 software. The project last edited is opened. If necessary, close this project by
selecting "File/Close".
• Familiarize yourself with the main window of the software.
ATTENTION
For a correct operation of the system, it is important to completely specify
(configure) the device configuration in the programming software. Otherwise
the system will bring up corresponding error messages! In case of errors,
please refer to the chapter "System Technology / Diagnosis System in AC500"
for required information.
To Next Page
Loading...
