Serial communications 151
ACH550-01 User's Manual
5102
…
5126
FB PAR 2…FB PAR 26 0…65535
Refer to the communication module documentation for more
information on these parameters.
5127 FBA PAR REFRESH 0=DONE, 1=REFRESH
Validates any changed fieldbus parameter settings.
0 =
DONE – Refreshing done.
1 =
REFRESH – Refreshing.
• After refreshing, the value reverts automatically to
DONE.
5128 FILE CPI FW REV 0…0xFFFF
Displays the CPI firmware revision of the drive’s fieldbus adapter
configuration file. Format is xyz, where:
• x = major revision number
• y = minor revision number
• z = correction number.
Example: 107 = revision 1.07
5129 FILE CONFIG ID 0…0xFFFF
Displays the revision of the drive’s fieldbus adapter module’s
configuration file identification.
• File configuration information depends on the drive application
program.
5130 FILE CONFIG REV 0…0xFFFF
Contains the revision of the drive’s fieldbus adapter module
configuration file.
Example: 1 = revision 1
5131 FBA STATUS 0…6
Contains the status of the adapter module.
0 =
IDLE – Adapter not configured.
1 =
EXECUT INIT – Adapter is initializing.
2 =
TIME OUT – A time-out has occurred in the communication between
the adapter and the drive.
3 =
CONFIG ERROR – Adapter configuration error.
• The major or minor revision code of the adapter’s CPI firmware
revision differs from that stated in the drive’s configuration file.
4 =
OFF-LINE – Adapter is off-line.
5 =
ON-LINE – Adapter is on-line.
6 =
RESET – Adapter is performing a hardware reset.
5132 FBA CPI FW REV 0…0xFFFF
Contains the revision of the module’s CPI program. Format is xyz,
where:
• x = major revision number
• y = minor revision number
• z = correction number.
Example: 107 = revision 1.07
Code Description Range
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
