Chapter 3 – Electrical Installation
ACS/ACC/ACP 601 Drives ACx=ACS/ACC/ACP 3-9
Figure 3-6 Replacing the front cover
Control Panel in
Remote Use
Connect the Control Panel cable to terminal X19 of the NAMC-11, or
with NAMC-03 board to terminal X28 of the NIOC board (X300 of the
NIOCP board).
Frames R4 to R6
1. Replace the front cover.
2. Replace the telephone connector.
3. Attach the Control Panel by pushing it softly down onto the
connector in the front cover hollow.
Frames R2 to R3
Frame R7
Connect the Control Panel cable to the connector X2,
and replace the front cover.
NIOCP board
X300
X19
NAMC-11 with NDCO
X19
NAMC-11
ACx 601/604 with NAMC-11 board
ACx 601/604 with NAMC-3 board and ACx 607
NIOC
X28
Ground the cable
screen at the near
Grounding screw.
To Next Page
Loading...
