06 MECHANICAL INSTALLATION
3BHS213401 E01 REV H ACS1000 AIR-COOLED USER MANUAL 77/184
6.1 Safety
6.2 Overview of installation work
The installation includes the following work:
- “6.4 Preparing the floor” on page 78
- “6.5 Fixing the cabinet to the floor” on page 78
- “6.6 Assembling and installing the air exhaust hood” on page 79
- “6.7 Installing the redundant fan unit” on page 80
6.3 General notes on installation
NOTICE
6.3.1 Dimensions and clearances
6.3.2 Cabinet roof
The cabinet roof is not designed as a mounting base for, eg, foreign devices, cable ducts.
Therefore, it is not permitted to install any foreign device on the roof.
6.3.3 Fire protection
6.3.4 Cable duct material
- Use non-flammable material with non-abrasive surface.
- To prevent dust, humidity and animals entering the cabinet, protect the cable entries.
▲
⚠
All installation work must be carried out by qualified personnel according to the site
and equipment requirements and in compliance with local regulations.
Risk of component damage!
- Foreign matter and particularly metallic dust can cause failure and damage
when the drive is energized.
- Ensure that foreign matter cannot enter the cabinet:
• Close the doors and cover openings completely when work is discontinued.
• Retrieve any foreign matter which accidentally dropped into the cabinet.
See Appendix C – Mechanical drawings for information on:
- Cabinet dimensions
- Clearances to be observed
- Mounting hole sizes
- To prevent fire spreading into the drive, apply suitable fire protection measures.
To Next Page
Loading...
