ABB ACS880-01-061A-3+N5350 - Page 195

A-2 Technical Specications 3AXD50000011888
Digital Inputs
DI1...DI6
(XDI:1...XDI:6)
Connector pitch 5 mm, wire size 2.5mm
2
24V logic levels: “0” < 5V, “1” > 15V
R
in
: 2.0 kohm
Input type: NPN/PNP (DI1…DI5), NPN (DI6)
Hardware ltering: 0.04ms, digital ltering up to 8ms
DI6 (XDI:6) can alternatively be used as an input for PTC sensors
“0” > 4kohm, “1” < 1.5kohm
I
max
: 15mA (for DI6 5mA)
Start Interlock
Input DIIL (XD24:1)
Connector pitch 5mm, wire size 2.5mm
2
24V logic levels: “0” < 5V, “1” > 15V
R
in
: 2.0 kohm
Input type: NPN/PNP
Hardware ltering: 0.04ms, digital ltering up to 8ms
Digital Inputs/
Outputs DIO1 and
DIO2 (XDIO:1 and
XDIO:2)
Input/output
selection by
parameters.
DIO1 can be
congured as a
frequency input
(0…16 kHz with
hardware ltering
of 4 microseconds)
for 24V level
square wave signal
(sinusoidal or other
wave form cannot
be used).
DIO2 can be
congured as a 24V
level square wave
frequency output.
See the rmware
manual, parameter
group 11.
Connector pitch 5mm, wire size 2.5mm
2
As inputs:
24V logic levels: “0” < 5V, “1” > 15V
R
in
: 2.0 kohm
Filtering: 0.25ms
As outputs:
Total output current from +24VD is limited to 200mA.
Figure A-1
R
L
DIOx
DIOGND
+24VD
Reference Voltage
for Analog Inputs
+VREF and -VREF
(XAI:4...XAI:2)
Connector pitch 5mm, wire size 2.5mm
2
10V ±1% and –10V ±1%, R
load
1…10kohm
Analog Inputs AI1
and AI2 (XAI:4...
XAI:7)
Current/voltage
input selection by
jumpers.
Connector pitch 5mm, wire size 2.5mm
2
Current input: –20…20mA, R
in
: 100ohm
Voltage input: –10…10V, R
in
: > 200kohm
Differential inputs, common range ±30V
Sampling interval per channel: 0.25ms
Hardware ltering: 0.25ms, adjustable digital ltering up to 8ms
Resolution: 11 bit + sign bit
Inaccuracy: 1% of full scale range
Table A-1 ACS880+N5350 Technical Data Continued