ABB CoreSense M10 - Powering up the Coresense M10; Establishing SCADA Connections

56 Installation Guide
Powering up the CoreSense M10
NOTICE
NEVER try and start the system if the ambient temperature is below –40 °C (–40 °F).
Once all connections are properly set, you can power up the monitoring system.
To do so, simply close each breaker switch, as shown in Figure 40.
—
Figure 40 Pulling the breaker switches to power up the monitoring system
Establishing SCADA connections
ABB recommends using a Cat5 Ethernet cable.
NOTICE
Do not use the optical Ethernet port when using the copper-based SCADA Ethernet port.