ABB DriveIT ACH550-UH - Page 54

54 ACH550-UH User’s Manual
Start-Up
0118 DI1-3 STATUS 000…111 1 -
(0…7 decimal)
Status of the three digital inputs.
• Status is displayed as a binary number.
• 1 indicates that the input is activated.
• 0 indicates that the input is deactivated.
0119 DI4-6 STATUS 000…111 1 -
(0…7 decimal)
Status of the three digital inputs.
• See parameter 0118 DI1-3 STATUS.
0120 AI1 0…100% 0.1% -
Relative value of analog input 1 in %.
0121 AI2 0…100% 0.1% -
The relative value of analog input 2 in %.
0122 RO1-3 STATUS 0…111 1 -
(0…7 decimal)
Status of the three relay outputs.
• 1 indicates that the relay is energized.
• 0 indicates that the relay is de-energized.
0123 RO4-6 STATUS 0…111 1 -
(0…7decimal)
Status of the three relay outputs. See parameter 0122.
0124 AO1 0…20 mA 0.1 mA -
The analog output 1 value in milliamperes.
0125 AO2 0…20 mA 0.1 mA -
The analog output 2 value in milliamperes.
0126 PID 1 OUTPPUT -1000…1000% 0.1% -
The PID Controller 1 output value in %.
0127 PID 2 OUTPUT -100…100% 0.1% -
The PID Controller 2 output value in %.
0128 PID 1 SETPNT - - -
The
PID 1 controller setpoint signal.
• Units and scale defined by PID parameters 4006/4106 & 4007/4107.
0129 PID 2 SETPNT - - -
The
PID 2 controller setpoint signal.
• Units and scale defined by PID parameters 4206 & 4207.
0130 PID 1 FBK - - -
The
PID 1 controller feedback signal.
• Units and scale defined by PID parameters 4006/4106 & 4007/4107.
Group 01: Operating Data
Code Description Range Resolution Default S
DI 1
DI 2 DI 3
RELAY 1 STATUS
RELAY
2 STATUS
RELAY
3 STATUS