S P I R I T
IT
F L O W- X INS T R U C T I O N M A N U A L | I M/ F L O W X - EN 35
Software installation
Software installation is quite straightforward.
You will need administrator rights in order to install. Refer to
your system administrator if you are not sure you have these
rights on the account you use.
Insert the CD in your CD-drive while your computer is running.
The CD will normally autostart and present the installation Start-
up display. Follow the instructions from there.
If autostart is disabled on your system, use Explorer to navigate
to your CD-drive and start setup.exe.
Note: Any existing version will automatically be
replaced. If a version of 1.7.x or earlier was installed then
the user will have to confirm this.
After installation, you will need to get a license from ABB Spirit
IT
based on the unique Machine ID that your computer will provide,
in order to use the configuration software. Depending on your
license you may be able to run Spirit
IT
Flow-Xpress in Basic mode
or also in Professional mode.
Refer to Volume II-A of this manual set for detailed
installation instructions and for use of the Spirit
IT
Flow-
Xpress software to configure your modules.
To Next Page
Loading...
Need help?
General
