InSite Flat Cable
The INS105 flat cable is a 4-pin cable for connecting multiple sensors and I/O modules to one control unit.
Please take into account that possible cable length of the InSite flat cable depends on the number and
shape of sensors, and on the number of I/O modules connected.
• Do not exceed a total flat cable length of 32m for all InSite-Bus lines for each control unit.
•
wires at the far end.
• For the flat cable, please consider:
• Use within closed housings only
• Keep a distance of min. 5.5 mm to uninsulated live parts
• Where necessary, additional protection against mechanical stress or UV radiation must be ensured.
• Interactive guide for calculation of maximum cable length under consideration of devices placement is
available as a separate tool, available at link at pag. 22.
Connector set
The INS135 connector set contains connector housings and connectors to connect the flat cable to the
sensors.
35 x Connector
35 x Connector housing
14 SCU100 INSITE PRO M COMPACT USER MANUAL
To Next Page
Loading...
