11.5.General
Time
• Time settings
It is possible to synchronize the time to compare the time of the device and the one on the web browser.
The synchronization is mandatory in order to correctly visualize and store data.
By clicking on “Synchronize” button, the Control Unit will synchronize with the web browser time.
Please note: if device time differs by more than 10min from the web browser time, a warning message will
be shown.
• Set time manually
It is also possible to manually set the time. Please select date and time using calendar and clock icons.
• NTP
If an NTP Server is available you can set the IP address (Time Server 1, Time Server 2) for automatic time
synchronization. In this case, the synchronization procedure can take up to 10 minutes.
Please make sure that no firewall will block the NTP server.
Check the internal time of the device in order to guarantee correct operation of the SCU100. If it is not
correct, it has to be set manually.
Please keep attention: incorrect date and time settings may cause device malfunction.
SCU100 INSITE PRO M COMPACT USER MANUAL 53
To Next Page
Loading...
