Assembly of I/O modules
• Assembly on 35mm DIN-Rail
To assemble of the control unit, perform steps 1 and 2. The device can be mounted horizontally or
vertically. To disconnect, perform steps 3, 4 and 5.
Final connection
Finally, connect the current sensors and the I/O modules to the control unit.
Plug in the cable, check the correct connection direction. (Picture to the right)
Attention: When plugging in the InSite flat cable on the sensors and I/O modules, check the correct
connection direction.
1
2
3
4
5
SCU100 INSITE PRO M COMPACT USER MANUAL 25
To Next Page
Loading...
