ABB IRB 660 - Page 147

NoteAction
Check the o-ring grooves.3
The grooves must be geometrically correct and
should be free of pores and contamination.
Lubricate the o-ring with grease.4
Tighten the screws evenly while assembling.5
Check that the o-ring is not squashed outside
the o-ring groove.
6
Product manual - IRB 660 147
3HAC025755-001 Revision: W
© Copyright 2006-2020 ABB. All rights reserved.
4 Repair
4.2.3 Mounting instructions for sealings
Continued