ABB Relion 670 series - Page 1353

PosNo Description Quantity Type
1 Bushing 4 -
2 Screw 8 M4x10
3 Screw 4 M6x12 or
corresponding
4 Mounting bar 2 -
5 Screw 6 M5x8
6 Side plate 2 -
22.4.3.3 How to reach the rear side of the IED
M11941-2 v5
The IED can be equipped with a rear protection cover recommended to be used with this type of
mounting. See figure 685.
To reach the rear side of the IED, a free space of 3.2 inches is required on the unhinged side.
3.2"
View from above
1
ANSI_en06000135.vsd
3
2
(80 mm)
ANSI06000135 V1 EN-US
Figure 685: How to reach the connectors on the rear side of the IED.
PosNo Description Type
1 Screw M4x10
2 Screw M5x8
3 Rear protection cover (Ordered separately)
1MRK 502 066-UUS B Section 22
IED hardware
1347
Technical manual