ABB RER615 - System or Device; Network Configuration; Physical Layer

Function or ASDU is not used
Function or ASDU is used as standardized (default)
Function or ASDU is used in reverse mode
Function or ASDU is used in standard and reverse mode
The possible selection (blank, X, R, or B) is specified for each specific clause or
parameter.
The full specification of a system may require individual selection
of certain parameters for certain parts of the system, such as the
individual selection of scaling factors for individually addressable
measured values.
3.3 System or device
(System-specific parameter, indicate the station's function by marking one of the
following with “X”.)
System definition
Controlling station definition (master)
Controlled station definition (slave)
3.4 Network configuration
(Network-specific parameter, all configurations that are used are to be marked with
“X”.)
Point-to-point
Multipoint-party line
Multiple point-to-point Multipoint-star
3.5 Physical layer
(Network-specific parameter, all configurations and data rates that are used are to
be marked with “X”.)
Section 3 1MRS757824 C
IEC 60870-5-101/104 protocol implementation
52 Recloser Protection and Control RER615
Point List Manual