ABB RER615 - LD0.T1 PTTR1 Thermal Overload Values (1); LD0.DARREC1 Autorecloser (1); LD0.SECRSYN1 Synchrocheck (1)

Object type Addr IEC 61850 name SA name Description Values
21 10111 .FltNum.stVal - Number of DR recordings 0...65535
21 10112 .MemUsed.stVal - DR Rec. memory used 0...100 [%]
LD0.LPHD1
21 10005 .PhyHealth.stVal Device Health 0=OK; 1=Warn; 2=Error
21 10006 .PhyHealth1.stVal Warning See the technical
manual.
21 10007 .PhyHealth2.stVal Internal fault See the technical
manual.
21 10003 .NumCmpChg Num of comp changes 0...999999
21 10004 .NumPwrUps.stVal Num of power ups 0...999999
21 10009 .WrmStr.stVal Num of warm starts 0...999999
21 10008 .WacTrg.stVal Num of wdog starts 0...999999
2.4.3 LD0.T1PTTR1 Thermal overload values (1)
Table 83: LD0.T1PTTR1 Thermal overload values (1)
Object type Addr IEC 61850 name SA name Description Values
LD0.T1PTTR1
20 10142 .Tmp.mag TEMP Object temperature -100.0...9999.9 [C]
20 10143 .TmpRI.mag TEMP_RL Relative temperature 0.00...99.99 [C]
21 10144 .TmmsOp.stVal THERMLEV_ST Est. time to operate 0...600.000 [ms]
21 10145 .TmmsRecEna.stVal THERMLEV_END Est. time to deactivate block 0...600.000 [ms]
2.4.4 LD0.DARREC1 Autorecloser (1)
Table 84: LD0.DARREC1 Autorecloser (1)
Object type
Addr IEC 61850 name SA name Description Values
LD0.DARREC1
21 10103 .AutoRecSt.stVal STATUS Autorec. status -2...4
21 10104 .ShotPntr.stVal SHOT_PTR Shot pointer value 0...65535
2.4.5 LD0.SECRSYN1 Synchrocheck (1)
Table 85: LD0.SECRSYN1 Synchrocheck (1)
Object type
Addr IEC 61850 name SA name Description Values
LD0.SECRSYN1
21 10163 .EnSt.stVal ENERG_STATE Energ. state of line and bus 0...4
See the technical
manual.
Section 2 1MRS757824 C
IEC 60850-5-101/104 data mappings
40 Recloser Protection and Control RER615
Point List Manual