ABB Terra 360 CE - Connect the Ethernet Cable (Terra 180)

To Next Page

To Previous Page

Procedure

1. Connect the Ethernet connector (A) to the Ethernet cable (B).

The Ethernet cable connection is in location (C) inside the EVSE.

5.7.9 Connect the Ethernet cable (Terra 180)

Preliminary requirements

• The front door is open.

•

Installation engineer

Installation

74 9AKK108467A6398-EN | 002

Main Page

Table of Contents3
About this Document9
Function of this Document9
Disclaimer9
Target Group9
Revision History9
Language9
Illustrations9
Units of Measurement10
Typographical Conventions10
How to Use this Document10
General Symbols and Signal Words Used in the Document10
Manufacturer and Contact Data11
Abbreviations12
Terminology12
Orientation Agreements13
Safety14
Liability14
General Safety Instructions14
Responsibilities for the Owner15
Required Qualifications for the Installation Engineer15
Personal Protective Equipment16
Safety Instructions During Transport16
Safety Instructions During Installation16
Safety Instructions for Use17
Safety Instructions During Cleaning or Maintenance17
Safety Instructions for Earthing17
Signs on the EVSE18
Discard the EVSE or Parts of the EVSE18
Cyber Security19
Description20
Type Plate20
Intended Use20
Working Principles22
Block Diagram - Terra 36022
Terra 360 - 2 Outlets, 25 Percent24
Terra 360 - 2 Outlets, 50 Percent25
Block Diagram - Terra 18026
Block Diagram - Terra 60 CC and CJ/C28
Overview30
Overview of the System30
Overview of the Terra 60, Outside31
Overview of the Terra 60, Inside32
Overview of the Terra 60, Air Inlet/Outlet and Filter Locations33
Overview of the Terra 180, Outside34
Overview of the EVSE, Inside35
Overview of the Terra 180, Air Inlet/Outlet and Filter Locations36
Overview of the Terra 360, Outside37
Overview of the Terra 360, Inside38
Overview of the Terra 360, Air Inlet/Outlet and Filter Locations39
Overview of the Cable Management System40
Overview of the Locations of the Lifting Points40
Authorization to Charge41
Payment Terminal41
Options42
EV Charge Cable, CCS 142
EV Charge Cable, CCS 242
Socket, Type 243
EV Charge Cable, Chademo43
Integrated Payment Terminal43
Integrated Payment Terminal - Nayax44
Integrated Payment Terminal - CCV44
Fiscal Metering System44
Tilt Sensors45
Cable Management System46
Power Allocation Strategies46
Sequential Power Allocation46
Concurrent Allocation47
Dynamic Allocation 'First in First Served47
Dynamic Allocation 'Fair Share48
External Residual-Current Device48
Description of the Touchscreen49
General Description of the Layout49
General Description of the Buttons50
Status of the EVSE Leds51
Local Service Portal51
Cloud Service Portal52
Transport, Handling and Unpacking53
Transport the EVSE to the Site53
Hoist the Packaged Cabinet53
Move the Packaged Cabinet with a Forklift Truck54
Unpacking55
Unpacking Procedure55
Do a Check of the Transport Sensors56
Installation57
General Installation Procedure57
Site Preparation57
Prepare the Site57
Control the Space and Airflow Around the Cabinet58
Prepare the Foundation58
Prepare the Foundation - General Procedure58
Prepare a Standard Prefabricated Foundation59
Prepare a Cast Foundation59
Detach the Cabinet and Base59
Detach the Cabinet (Terra 360)59
Detach the Cabinet (Terra 180 and 60)60
Detach the Base61
Prepare the Cables62
Cable Installation Procedure62
Open the Cable Glands (Terra 360)62
Open the Cable Glands (Terra 60 and 180)63
Guide the Cables through the Opening in the Cable Guide Plate63
Install the Base on the Foundation64
Cut the Cables to the Correct Length64
Mechanical Installation65
Mechanical Installation Procedure65
Install the Cabinet on the Base65
Connect the Cabinet to the Base66
Electrical Installation66
Electrical Installation Procedure66
Connect the Wires of the AC Input Cable (Terra 360)67
Connect the Wires of the AC Input Cable (Terra 180)68
Connect the Wires of the AC Input Cable (Terra 60)69
Connect the PE Wire (Terra 360)71
Connect the PE Wire (Terra 180 and 60)72
Connect the Ethernet Cable (Terra 360)73
Connect the Ethernet Cable (Terra 180)73
Connect the Ethernet Cable (Terra 180)74
Tilt Sensors Installation (Option)75
General Procedure75
Install the Bracket of the Tilt Sensors76
Install the Tilt Sensors76
Connect the Tilt Sensors77
Prepare for Commissioning77
Operation79
Prepare before Use79
Charge Session79
Charge an EV79
Start a Charge Session79
Stop a Charge Session80
Energize the EVSE80
Remove Condensation from the Cabinet81
Local Service Portal Operations81
Start the Local Service Portal81
Set the Configuration Parameters82
Set the OCPP Parameters82
Install New Software82
Close the Local Service Portal83
Maintenance and Cleaning84
Maintenance Schedule for the Owner84
Clean the Cabinet84
Do a Check on the Cabinet85
Replace an Air Filter85
Energize the EVSE87
De-Energize the EVSE - General Procedure87
Measure the AC Voltage (Terra 360)87
Measure the AC Voltage (Terra 180)88
Measure the AC Voltage (Terra 60)88
Measure the DC Voltage89
Access to Parts90
Open the Doors90
Close the Doors90
Install the Border Covers91
Remove the Border Covers91
Troubleshooting93
Troubleshooting Procedure93
Troubleshooting Table93
Technical Data94
EVSE Type94
General Specifications97
Parts Included in the Delivery97
Transport Specifications97
Required Tools for Installation97
Required Parts for Installation98
Torque Specifications98
Ambient Conditions99
Tilt Sensor Specifications99
General Specifications99
Wire Specifications99
Wiring Diagram for the Tilt Sensors100
Cable Management System Specifications101
Dimensions101
General Dimensions (Terra 360)101
General Dimensions (Terra 180 and 60)102
Packaged Product102
Mass of the EVSE (Without Packaging Material)103
Floor Space Requirements (Terra 360, Pre-Series)103
Floor Space Requirements (Terra 360, Serial Production)104
Floor Space Requirements (Terra 180 and 60)105
Prefabricated Foundation (Terra 360)106
Cast Foundation (Terra 360)107
Cast Foundation (Terra 180 and 60)108
Cable Slack108
Height of User Operable Elements109
Communication Interface Specifications110
EVSE Power Rating110
EVSE Rating During Normal Duty Operation110
EVSE Derating During Normal Duty Operation110
EVSE Rating in Heavy Duty Operation111
EVSE Derating During Heavy Duty Operation112
Harmonics112
Harmonics Terra 360, Equal Share112
Terra 180, Equal Share114
Harmonics Terra 60116
AC Input Specifications117
General AC Input Specifications117
AC Input Cable118
Terra 360118
Terra 180118
Terra 60119
DC Output Specifications119
General Specifications119
Terra 360121
Terra 180122
Terra 60124
AC Output Specifications (Option for 180 and 60)124
Power Consumption124
General Specifications124
Terra 360124
Terra 180124
Cooling System Specifications124
External Residual Current Device Specifications125
External Residual Current Device (Terra 360)125
External Residual Current Device (Terra 180)126
External Residual Current Device (Terra 60)127
In-Rush Current128
Cleaning Specifications128
Appendix129
Declaration of Conformity129
Hinweise zur Messgenauigkeit Entsprechend der Baumusterprüfbescheinigung131

ABB Terra 360 CE - Connect the Ethernet Cable (Terra 180)

Table of Contents

Related product manuals