ABB Terra 360 CE - Tilt Sensors Installation (Option); General Procedure

Procedure
1. Connect the Ethernet connector (A) to the Ethernet cable (B).
The Ethernet cable connection is in location (C) inside the EVSE.
5.8 Tilt sensors installation (option)
5.8.1 General procedure
For all specifications of the tilt sensors, refer to section 10.9.
1. Install the bracket (A). Refer to section
5.8.2.
2. Install the tilt sensors. Refer to section
5.8.3.
3. Connect the tilt sensors.
C
B
A
A
Installation
9AKK108467A6398-EN | 002 75