ABB TPL73-A30 - Page 112

Operation Manual / TPL69-A10 / -A30 ... TPL77-A10 / -A30
Disassembly and assembly
8
Installing cartridge group
8.7
Page 110
© Copyright 2016 ABB.
All rights reserved.
December 2016 HZTL2481_EN Revision B

Check that nuts (90458) on three safety segments have been tight-
ened.
 Fasten lifting device (90190) complete with shackle (90195) to front
side of flange (
F
).
 Fit O-ring (76040).
 Remove support angle. (90025)
 Fit four guide studs (90320).
 Carefully put compressor casing internal part complete with wall insert
and diffuser over guide studs.
 Remove the guide studs (90320) and fit the studs (74026/74029).
 Use studs [10x 74029 and 2x 74026 (each screwed in at top and bot-
tom)].
If provided