Operation Manual / TPL69-A10 / -A30 ... TPL77-A10 / -A30
Taking out of operation at short notice
Page 126
© Copyright 2016 ABB. All rights reserved.
December 2016 HZTL2481_EN Revision B
Fit locking flange (94003) using nuts (74027) and then screws (94007 /
94006) and tighten according to
Table of tightening torques
.
In the case of engines with three or four turbochargers, the balancing
screws should be removed from the compressor wheel concerned.
In the case of engines with one or two turbochargers, eight screws are
enough to securely fasten the locking flange.
To Next Page
Loading...
