To Next Page

To Previous Page

Error resolution and maintenance – Taking the Wallbox eMH3 out of operation |

Taking the Wallbox eMH3 out of operation

In case of severe malfunctions or damage to the device, you must take the Wallbox eMH3 out of operation.

To do so, proceed as follows:

1 Open the housing cover of the wallbox using the

triangular key and lower it.

2 Flick the pivot lever of the internal RCCB (TWIN

wallboxes: both RCCBs) into the 0 position (connec-

tion to the electricity grid is interrupted).

y Also flip the pivot lever of the internal MCB to

position 0.

3 Flip the housing cover up so that it clicks into the

housing and lock it with the triangular key.

METER

CONTROL

METER

4 Open your domestic power distribution box, discon-

nect the power supply cable from the electricity grid

via the MCB and close the distribution box.

The Wallbox eMH3 is no longer connected to the electricity grid and can be removed by a qualified specialist electri-

cal contractor if required.

Other manuals for ABL Wallbox eMH3

Questions and Answers:

Need help?

Do you have a question about the ABL Wallbox eMH3 and is the answer not in the manual?

General