Abus HDCC90002 - Add Network Drive; Storage Mode

85
Attention: If only one hard disk is installed and this is given the status "Read only",
the unit cannot perform any recordings!
Add network drive
Click on "Add" to add a network drive.
Attention: It is recommended to use a separate volume on the NAS for each NVR,
as multiple use could lead to problems.
Storage mode
 Sleeping (=Standby)
Properties
Displays the access status of the hard disk:
 Read only: Write protection
 Reading/Writing: Reading and writing
Type Displays the connection type of the hard disk:
 Local: Device hard disk
 NAS: Network Hard Drive (NFS)
 IP SAN: iSCSI Volume
Verf. memory
Displays the free memory space
Group
Shows which group the hard disk is assigned to
Editing
Here you can change the group assignment and the access status
 HDD No.: Internal numbering of the hard disks
 R/W: In this mode, video data is written to the hard disks
and can also be read (default setting).
 Read only: In this mode, no video data is written to the data
carrier. This setting is helpful if overwriting of the data is to
be prevented after an event.
 Redundant: In this mode, video data is saved redundantly
on all data carriers with the "Redundant" setting. To do this,
the "Redundant" button must be set in the menu
"Recording Parameters Further settings".
 Group: Assignment of the hard disk to an HDD group
Delete
Deactivate / activate hard disk
Network drive Choose between 8 network drives.
Type
 NAS: For this setting, your network storage must support the
NFS file system.
 IP SAN: For this setting, your network storage must support
the iSCSI protocol.
IP address Enter the IP address of the network stora
g
e here.
Director
y
Click on "Search" to select the path or enter it directl
y
.