Abus HDCC90002 - Advanced Settings

88
Here you can set up the automatic backup. The last 24 hours are automatically
exported to a USB / eSATA device.
Backup status The progress of the backup is displayed
here
Current status Displa
y
s the current status.
Last Backup This shows whether the last backup was
successful
Auto Backup Here you can set the backup to be
carried out automaticall
y
ever
y
da
y
.
Start time Here you enter when the backup should
start
Cameras Here you can select the camera channel
for which the backup is to be made.
Backup Stream Type Here you can select for which stream the
backup should be made
Destination The device type to be used for the
backup is selected here
Select unit Here you select the connected device.
USB or eSATA
(
if available
)
Overwrite This option sets whether the already
existing data of the connected unit may
be overwritten.
Advanced settings
Here you can make general settings for all installed hard disks.
RAID:
In this menu you can create a RAID array for recording the video data on the
recorder.
Attention:
Overwrite
Set whether older recordings should be overwritten when the
hard disk is full.
HDD sleep function
When this function is activated, hard disks that are idle go into
stand-by mode.
RAID
Activate the integrated RAID controller here (NVR10040
only).