Abus HDCC90002 - Page 89

89
RAID is a software RAID function. This means that the RAID data is managed by the
integrated CPU of the recorder. If the function is activated, the INPUT bit rate of the
NVR is reduced by approx. 40%.
Physical data carrier:
This view shows a list of all data carriers connected to the NVR. The following
options are available for further configuration:
Note
If you would like more information on the use of RAID, please consult the relevant
technical literature.
Array:
This view shows the current state of the RAID array. The following actions can be
performed:
Quick
confi
g
uration
Automatically creates a RAID array from all free data carriers.
Create
Manual creation of a RAID array. The following RAID types can be used:
RAID0, RAID1, RAID5, RAID10.
Hotspare
Free data carriers that are not assigned to a RAID array can be defined as
"hotspare". These data carriers are initially not used by the system. If a
data carrier error occurs in a RAID array, the hotspare data carrier is
immediately activated for use.
Re-Build Manually rebuild the array. This rebuilds the data structure of
the RAID arra
y
.
Delete Delete the RAID array. This "frees" the data carriers again
and the
y
can be used a
g
ain for RAID confi
g
urations.