FUBW35000 PIR Motion Detector
Catch for removing the rear panel
Button for manual pairing with the Smartvest
Activate test mode: press for 5 s
Deactivate test mode: press for 5 s
Tampering contact for alarming in the event of unwanted removal
3 x AA (1.5 V) batteries for power supply (up to two years battery life)
The Smartvest App warns you when the battery is low. Follow the instructions
in the app.
Changing the battery
Press the catch on the underside of the PIR Motion Detector and remove the
rear panel. Remove the dead 3 AA (1.5 V) batteries from the compartment
and replace with the new 3 AA (1.5 V) batteries. Make sure they are facing
in the direction shown on the compartment floor, Reattach the PIR Motion
Detector to the mounted rear panel.
In test mode, the PIR Motion Detector's energy-saving mode is deactivated so it triggers
each time motion is detected. Use this to check whether the detector fully covers the
monitored space. Deactivate test mode after use, as otherwise this will severely affect the
battery life.
FURM35000 smoke alarm/heat detector
Refer to the instructions for the smoke alarm/heat detector.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
