Hotkeys enable straightforward activation of various components with just a tap.
Should you become aware of any potential intruders outside your house before they have attempted
to break in, you could, for example, configure a hotkey (panic) to activate the siren, which you could
then tap to scare off the intruder before they break in.
Alternatively, you could create a user-defined hotkey to activate one or several power switches and
switch your home lighting on and off by tapping the hotkey.
Hotkey overview
Up to 11 hotkeys can be displayed in the hotkey overview. Two
pre-configured hotkeys – panic and camera – are already stored
upon initial start-up. In the settings (see chapter 5.3, Hotkeys),
you can add nine further hotkeys in the overview or edit the
hotkeys already available.
To do this, simply tap the desired hotkey.
There are two pre-configured hotkeys – panic and camera – in the
hotkey overview. These two hotkeys are also found on the
FUBE35000 Remote Key and can be operated from there.
All actuators are triggered (e.g. sirens) and all
cameras are recording
All cameras are recording
When pairing components, standard values are
automatically set for the pre-configured hotkeys.
Should you wish to alter the component settings for
the hotkey in question, you can find the settings
under point 5.3, Hotkeys.
Configurable hotkeys
You can configure up to nine hotkeys in the settings (see chapter
5.3, Hotkeys). Once created, these are then shown in the hotkey
overview and can be tapped and run.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
