Abus Smartvest User Manual

33
English
Hotkeys
There are two pre-configured hotkeys – panic and camera –
below the status display, which you can tap and enable in the
overview. These two hotkeys are also found on the FUBE35000
Remote Key and can be operated from there.
Standard:
All actuators are triggered (e.g. sirens) and all
cameras are recording
Standard:
All cameras are recording
Note
When pairing components, standard values are
automatically set for the pre-configured hotkeys.
Should you wish to alter the settings for the hotkey in
question, you can find the settings under point 5.3,
Hotkeys.
Fault
Should any faults occur (e.g. battery dead), these are shown
below the hotkeys. Once the faults have been remedied, they are
no longer shown in the overview.
You can also find the fault messages in the event overview (4.7).
Active devices
Components with an active status (e.g. power switch "on") are
displayed in a list. Once the components are deactivated, they are
no longer shown in the overview.
This means you always have an overview of any devices
consuming power.

Abus Smartvest Specifications

General

Certification	CE, GS
Maximum power	3680 W
Product color	White
LED indicators	Yes
AC input voltage	250 V
Connector gender	Male/Female
Housing material	Acrylonitrile butadiene styrene (ABS)
Sockets quantity	1
Plug connector type	Type F
Maximum indoor range	30 m
Maximum outdoor range	100 m
RF transmission frequency	868 MHz

Weight and Dimensions

Depth	31 mm
Width	55 mm
Height	99 mm
Weight	129 g