Abus TVVR36500 - Private Zone; Tamper Surveillance

Camera
Private Zone
Select the camera channel to be processed under “Cam-
era”.
Use the mouse to drag one of the four private zones over
the image and press “apply”. The marked alarm zones
will be shown as black areas in the camera images of the
live view and recordings.
Tamper Surveillance
Select the camera channel to be processed under “Cam-
era”.
Tamper surveillance alarms you if the camera is covered.
Tick the Enable Tamper Surveillance box and define
any other optional parameters under Settings.
Settings
Arming Time Schedule tab
Here you set the times at which the reactions set in the
Linkage Action tab are triggered.
1. Select the day and enter the time schedule.
Note
Up to eight time slots, between 00:00 and 00:00,
can be defined in each case, but the individual
time slots must not overlap.
2. Under Copy, select whether or not the setting should
be applied to every day of the week and the holiday
settings.
3. Confirm the settings by clicking on Apply and exit
the menu by clicking on OK.
Linkage Action tab
Here you can configure the response of the recorder dur-
ing an event (e.g. motion detected) by ticking the corre-
sponding box.
Parameter Notifications
Full Screen Monitoring
The camera is displayed in
full screen in live view.
Audible Warning The
device does not have an
audible warning.
Notify Surveillance Cen-
tre
The CMS sends out a warn-
ing message.
Send Email An email is sent to a speci-
fied email address. See
page31
Trigger Alarm Output The alarm output is trig
gered
in the event of an alarm.
• Confirm the settings by clicking on Apply and exit
the menu by clicking on OK.
41